How To Install FLO Grips

Step 1: Remove the old bike grips.

Step 2: Slide the FLO Grip onto the handlebar. FLO Grips are side-specific, so ensure the bolt is facing the rider and the relief slot is facing down.

Step 3: Firmly press the rubber bar end plug onto the end of the handlebar using the palm of your hand. The grip should not move or wiggle if the bar end plug is properly seated.

Step 4: Tighten the M4 bolt until the grip is secure and doesn't slip when twisted. If you have a torque wrench, we recommend setting it to a maximum of 2Nm.