How To Wrap FLO Handles

Video and Step-by-Step Instructions for Installing New Grip Wrap on Zen Ride's FLO Handles

Step 1: Begin at the clamping end of the FLO Handle. Place one end of the wrap on the relief slot located on the underside of the handle.

Tip: The handles are asymmetrical, so both locking bolts should face you while riding. For best results, wrap in the direction the screw is pointing.

Step 2: Hold the end of the wrap in place with your thumb, then pull a few inches of the wrap taut (avoid overstretching). Wrap it once around the handle so that the starting end is secured beneath the first wrap.

Step 3: Continue holding the wrap taut and start wrapping it at an angle, ensuring that each new layer covers half of the previous one. Keep wrapping until you reach the other end of the FLO Handle.

Tip: If you reach the end of the handle with too much or too little wrap, simply unwrap and adjust the overlap as needed.

Step 4: Once you reach the end, trim the wrap at an angle parallel to the end of the handle. Leave a few millimeters of wrap extending past the end of the handle, then tuck it inside and secure it with the rubber bar end plug.

Back to Tech Info